đŠ« 2010 Jeep Grand Cherokee Oil Change Reset
Installthe new filter on to the engine block. Hand tighten the filter. 9. Using an oil filter wrench, tighten the filter 1 more revolution past hand tight. 10. Using a funnel, refill the engine with oil. The 4.7L engine requires 6 Quarts of oil. If you're using a 5 Quart jug, don't forget to add one additional quart.
Turnthe ignition switch to the RUN position. First, you turn the key just to the on position. So all the lights up on the dashboard and you donât start the vehicle. Depress the GAS PEDAL slowly three times. Then you need to step on the GAS pedal to the floor three times within 10 seconds and it should reset.
Justa quick video how to reset service oil light on jeep grand Cherokee
JeepGrand Cherokee Oil Change Procedure: Make sure vehicle is parked in a level spot. Start engine until it is up to operating temp and then shut it back down. Check engine oil level on dip stick and verify it has no prior issues such as low engine oil. Remove engine oil fill cap. Open center top engine cover to access engine oil filter cap.
2010JEEP Grand Cherokee Maintenance Light Reset Instructions. October 21, 2019 / Instructions. 1. Turn the ignition to run (one position before starting engine). 2. Fully depress the accelerator pedal slowly three times within 10 seconds. 3. Turn the ignition off and then start the engine to verify the indicator has been reset. â Previous Post.
Drainthe oil and start over with the oil recommended in the ownerâs manual. With this oil change, you must also replace the filter again. Once that is done, the Check Engine Light should turn off. 6. Reset Codes. If the sensor doesnât turn itself off, the Check Engine Light could remain on after an oil change.
Step4. Disconnect the scanner. Late model vehicles such as the Jeep Cherokee utilize a system known as On Board Diagnostics, or OBD II, to optimize the performance of the vehicle's emissions components. When one of these components fails, it will send a signal to the engine computer, which will trigger the check engine light in the dash.
JeepGrand Cherokee. Manufacturer: Jeep. Model: Jeep Grand Cherokee. For the 2010 model year Jeep Grand Cherokee we have found 9 trims and their corresponding recommended oil type. Click on the name of the trim to open up the panel and learn more about the oil type, volume and change period.
GrandCherokee. There are a couple ways to reset the radio in a Jeep Grand Cherokee. The first is what is called a soft reset. Push and hold the volume and two knobs at the same time for about 10 to 20 seconds until the radio power is off. Once the system shut off it will quickly turn back on and take about a minute or so to fully come
OilLife wont stay reset. Going on my 3rd or so oil change. I do the procedure of resetting the oil life (run position with engine off, press the pedal 3 times slowly, turn off the vehicle). I get the life to reset to 100%. But the next time i get into the vehicle the change oil warning is back on and the oil life tab is at 0% with 20,000
Wide launched in 2010 by Chrysler and Fiat. Just like the Liberty, it has a monocoque body, but its engines are located transversely, not longitudinally. The Cherokee is available with two new gasoline engines. A 2.4-liter inline-four from the Tigershark series and a 3.2-liter V-six from the Pentastar series. Oil Life Reset: Jeep Cherokee
TheCheck Engine Light comes on whenever the systems send out an abnormal reading. For that reason, many issues cause the warning. However, the most common causes are a loose gas cap, a bad EGR valve, a bad MAF sensor, a bad oxygen sensor, a worn-out catalytic converter or a bad ignition coil. 1. Loose Gas Cap.
.
2010 jeep grand cherokee oil change reset
